s

 

 
Home

 

 

 

 

       

HEAT SHRINK END CAPS HEAT SHRINK CABLE END CAPS HEAT SHRINK END CAPS HEAT SHRINK CABLE END CAPS HEAT SHRINK PRODUCTS PARTS COMPONENTS

Cable end sealing caps, heat shrink end caps, cable end sealing cap, bus bar insulation shrouds, heat shrinkable four way cable breakout, heat shrinkable right angle boot, heat shrink tube, cold shrink, cross linked polyolefin, insulation caps, end caps, rain sheds, cable termination kits ,heat shrinkable tubing,, dip moulding, Low voltage breakout, Cable Accessories ,India,

 
Cable End Sealing Caps are :
  • Suitable for Power Cables, Telecom Cables, Jelly Filled Cables & Optic Fibre Cable Compatible with most commonly used Cable Jackets i.e XLPE, PVC, PILC or Rubber Sheathed.
  • Quick & foolproof installation using simple tools.
  • A strong & permanent enviornmental seal.
  • Excellent resistance to weathering, moisture contamination & adverse environmental conditions.
  • Special adhesive lining provides seal on irregular cable sheaths.
  • Valved end Cap available for pressurized application.

SELECTION CHART

All dimensions are in mm

CODE NO. D MAX D MIN L T CABLE RANGE
BEC 001 12 4 33 2.3 4 - 8
BEC 101 20 7.5 55 2.5 8 - 16
BEC 201 40 15 90 3.3 15 - 35
BEC 301 55 25 125 3.8 25 - 47
BEC 401 75 35 140 3.8 35 - 68
BEC 501 100 45 160 4.0 45 - 90
BEC 601 130 60 160 4.6 64 - 120
BEC 701 158 60 165 4.6 64 - 145
SPECIFICATION (As per ASTM STANDARDS)
Heat Shrink Material : Cross Linked Polyolefin
Tensile Strength : 12 N/mm (MPA)
Elongation : 350%
Density : 1.20 gm/cm
Hardness : 50 Shore D
Thermal Ageing : 10% drop in physical properties
Water Absorption : <0.2%
Chemical Resistance : To dilute acids & alkalies, Salts etc.
Continuous Temperature limit : -40C to 125C
Shrink Temperature : 125C


 

INSTALLATION PROCEDURE


 


 

  • Clean the cable surface & place the End Cap over the Cable End. On new cable, surface cleaning is not necessary.
  • Heat the end seal with a kerosene or gas torch, starting from the closed end towards the open end.
  • When the end cap is fully shrunk the sealant will flow out the end cap indicating that the seal is completed. Allow to cool.
     

Cable end sealing caps, heat shrink end caps, cable end sealing cap, bus bar insulation shrouds, heat shrinkable four way cable breakout, heat shrinkable right angle boot, heat shrink tube, cold shrink, cross linked polyolefin, insulation caps, end caps, rain sheds, cable termination kits ,heat shrinkable Tubing,, dip moulding, Low voltage breakout, Cable Accessories ,India,

 

Manufacturers Exporters suppliers India Asian Indian Manufacturer Jamnagar Supplier

manuf